DSTREAM-PT This high-performance debug and parallel trace unit enable powerful debug and optimization of any Arm processor-based hardware target. Ideal for any Arm architectures, supporting a maximum of 19.2 Gbps parallel trace when used alongside Arm Development Studio.
DSTREAM-ST If your projects need fast downloads, high JTAG clock rates and limited parallel streaming trace, then the DSTREAM-ST is the debug probe of choice. Used alongside Arm Development Studio you can develop your software faster.
DSTREAM This debug and trace unit enable powerful debug and optimization of any Arm processor-based hardware target. Ideal for comprehensive debug of Arm architectures v4 to v8 up to 9.6 Gbps (parallel trace) when used alongside Arm Development Studio.
Features & Specifications
Debug protocol JTAG and SWD (serial-wire debug).
Target connectors Target connectors for the DSTREAM-PT probe include 20-pin Arm JTAG connector, 14-pin TI JTAG connector, 10-pin & 20-pin high-density CoreSight connectors, MIPI-60 (QSH) connector, single (16-bit) and dual (32-bit) MICTOR 38 connectors.
Trace bandwidth Trace capture of up to 32-bit wide trace ports, up to 300 MHz DDR (600 Mb/s per pin)
Software requirements This debug probe is best used alongside Arm Development Studio 2019.0 or later (sold separately). The probe may also be supported by third party tools.